• Atess 250kw HV 500-820v Battery Inverter

    Bidirectional battery inverter from 100kW to 1000kW, can be used alone or with
    solar charge controllers and other accessories for different application scenarios.

    R701960,00

    In Stock at Distribution Branch

    Atess 250kw HV 500-820v Battery Inverter

    R701960,00

    In Stock at Distribution Branch

  • Atess 100kw HV 500-820v Battery Inverter

    Bidirectional battery inverter from 100kW to 1000kW, can be used alone or with
    solar charge controllers and other accessories for different application scenarios.

    R401120,00

    In Stock at Distribution Branch

    Atess 100kw HV 500-820v Battery Inverter

    R401120,00

    In Stock at Distribution Branch

  • Atess 630kw HV 600-900v Battery Inverter

    Bidirectional battery inverter from 100kW to 1000kW, can be used alone or with
    solar charge controllers and other accessories for different application scenarios.

    R735386,67

    In Stock at Distribution Branch

    Atess 630kw HV 600-900v Battery Inverter

    R735386,67

    In Stock at Distribution Branch

  • Atess 500kw HV 600-900v Battery Inverter

    Bidirectional battery inverter from 100kW to 1000kW, can be used alone or with
    solar charge controllers and other accessories for different application scenarios.

    R601680,00

    In Stock at Distribution Branch

    Atess 500kw HV 600-900v Battery Inverter

    R601680,00

    In Stock at Distribution Branch

  • Victron Phoenix Inverter 12/375 230V VE.Direct IEC

    VE.Direct communication port The VE.Direct port can be connected to:

    • A computer (VE.Direct to USB interface cable needed)
    • Apple and Android smartphones, tablets, MacBook’s and other devices (VE.Direct Bluetooth Smart dongle needed)

    Fully configurable:

    • Low battery voltage alarm trip and reset levels
    • Low battery voltage cut-off and restart levels
    • Dynamic cut-off: load dependent cut-off level
    • Output voltage 210 – 245V
    • Frequency 50 Hz or 60 Hz
    • ECO mode on/off and ECO mode sense level

    Monitoring:

    • In- and output voltage, % load and alarms

    Proven reliability

    The full bridge plus toroidal transformer topology has proven its reliability over many years. The inverters are short circuit proof and protected against overheating, whether due to overload or high ambient temperature.

    High start-up power

    Needed to start loads such as power converters for LED lamps, halogen lamps or electric tools.

    ECO mode

    When in ECO mode, the inverter will switch to standby when the load decreases below a preset value (min load: 15W). Once in standby the inverter will switch on for a short period (adjustable, default: every 2,5 seconds). If the load exceeds a preset level, the inverter will remain on.

    Remote on/off

    A remote on/off switch can be connected to a two-pole connector, or between battery plus and the left-hand contact of the two-pole connector.

    LED diagnosis

    Please see manual for a description. To transfer the load to another AC source: the automatic transfer switch For our low power inverters, we recommend our Filax Automatic Transfer Switch. The Filax features a very short switchover time (less than 20 milliseconds) so that computers and other electronic equipment will continue to operate without disruption.

    Available with different output sockets

    DC connection with screw terminals

    No special tools needed for installation

    Battery Alarm

    An excessively high or low battery voltage is indicated by an audible and visual alarm, and a relay for remote signalling

    BMV Battery Monitor

    The BMV Battery Monitor features an advanced microprocessor control system combined with high resolution measuring systems for battery voltage and charge/discharge current. Besides this, the software includes complex calculation algorithms to exactly determine the state of charge of the battery. The BMV selectively displays battery voltage, current, consumed Ah or time to go. The monitor also stores a host of data regarding performance and use of the battery

     

    R2405,80

    In Stock at Distribution Branch

    Victron Phoenix Inverter 12/375 230V VE.Direct IEC

    R2405,80

    In Stock at Distribution Branch

  • Victron MultiPlus 48/1200/13-16 230V VE.Bus

    Unique PowerAssist feature

    The MultiPlus will prevent overload of a limited AC source, such as a generator or shore power connection. First, battery charging will automatically be reduced when otherwise an overload would occur. The second level will boost the output of a generator or shore side supply with power taken from the battery.

    Uninterrupted AC power (UPS function)

    In the event of a grid failure, or when shore or generator power is disconnected, the inverter within the Multi is automatically activated and takes over the supply to the connected loads. This happens so fast (less than 20 milliseconds) that computers and other electronic equipment will continue to operate without disruption.

    Virtually unlimited power thanks to parallel operation

    Up to 6 Multis can operate in parallel to achieve higher power output. Three phase or split phase operation is also possible. Please check our datasheets to see which models have paralleling, three phase and split phase capabilities.

    Remote Monitoring and Control

    When coupled with a GX device (e.g. Cerbo GX) you can monitor and control your Multi and system or systems’ locally (LAN) or remotely via the internet from anywhere in the world, using the free VRM app and free VRM portal website. Access can be from a phone, tablet, laptop or PC for multiple operating systems. There is no end to the level of control, from adjusting your Multi to auto starting a backupgenerator and more…

    R9633,93

    In Stock at Distribution Branch

    Victron MultiPlus 48/1200/13-16 230V VE.Bus

    R9633,93

    In Stock at Distribution Branch

  • Victron MultiPlus-II 48/3000/35-32 230V

    PowerAssist

    The MultiPlus-II will prevent overload of a limited AC source, such as a generator or shore power connection. First, battery charging will automatically be reduced when otherwise an overload would occur. The second level will boost the output of a generator or shore side supply with power taken from the battery.

    ESS: Energy Storage Systems

    The MultiPlus-II is the key component in a Victron ESS system, providing the flexibility to combine with MPPT Solar Chargers or Grid-tie PV Inverters. For examples and more detailed information see the ESS (Energy Storage System) manual.

    Uninterrupted AC power (UPS function)

    In the event of a grid failure, or when shore or generator power is disconnected, the inverter within the Multi is automatically activated and takes over the supply to the connected loads. This happens so fast (less than 20 milliseconds) that computers and other electronic equipment will continue to operate without disruption.

    Remote Monitoring and Control

    When coupled with a GX device (e.g. Cerbo GX) you can monitor and control your Multi and system or systems’ locally (LAN) or remotely via the internet from anywhere in the world, using the free VRM app and free VRM portal website. Access can be from a phone, tablet, laptop or PC for multiple operating systems. There is no end to the level of control, from adjusting your Multi to auto starting a backupgenerator and more…”

    R13229,60

    In Stock at Distribution Branch

    Victron MultiPlus-II 48/3000/35-32 230V

    R13229,60

    In Stock at Distribution Branch

  • Victron Quattro 48/5000/70-100/100-S 230V VE.Bus

    Two AC Inputs & two AC Outputs

    The Quattro can be connected to two independent AC sources, for example shore-side power and a generator, or two generators. The Quattro will automatically connect to the active source. The main output has no-break functionality. In the event of a grid failure, or shore or generator power being disconnected, the Quattro takes over the supply to the connected loads. This happens so fast (less than 20 milliseconds) that computers and other electronic equipment will continue to operate without disruption. The second output is live only when AC is available on one of the inputs of the Quattro. Loads that should not discharge the battery, such as air-conditioning or a water heater can be connected to this output.

    Unique PowerAssist feature

    The Quattro will prevent overload of a limited AC source, such as a generator or shore power connection. First, battery charging will automatically be reduced when otherwise an overload would occur. The second level will boost the output of a generator or shore side supply with power taken from the battery.

    Virtually unlimited power thanks to parallel operation

    Up to 6 Quattros can operate in parallel to achieve higher power output. Three phase or split phase operation is also possible. Please check our datasheets to see which models have paralleling, three phase and split phase capabilities.

    Remote Monitoring and Control

    When coupled with a GX device (e.g. Cerbo GX) you can monitor and control your Quattro and system or systems’ locally (LAN) or remotely via the internet from anywhere in the world, using the free VRM app and free VRM portal website. Access can be from a phone, tablet, laptop or PC for multiple operating systems. There is no end to the level of control, from adjusting your Quattro to auto starting a backupgenerator and more…

    R44370,07

    In Stock at Distribution Branch

    Victron Quattro 48/5000/70-100/100-S 230V VE.Bus

    R44370,07

    In Stock at Distribution Branch

  • Victron Quattro 48/10000/140-100/100 230V VE.Bus

    Two AC Inputs & two AC Outputs

    The Quattro can be connected to two independent AC sources, for example shore-side power and a generator, or two generators. The Quattro will automatically connect to the active source. The main output has no-break functionality. In the event of a grid failure, or shore or generator power being disconnected, the Quattro takes over the supply to the connected loads. This happens so fast (less than 20 milliseconds) that computers and other electronic equipment will continue to operate without disruption. The second output is live only when AC is available on one of the inputs of the Quattro. Loads that should not discharge the battery, such as air-conditioning or a water heater can be connected to this output.

    Unique PowerAssist feature

    The Quattro will prevent overload of a limited AC source, such as a generator or shore power connection. First, battery charging will automatically be reduced when otherwise an overload would occur. The second level will boost the output of a generator or shore side supply with power taken from the battery.

    Virtually unlimited power thanks to parallel operation

    Up to 6 Quattros can operate in parallel to achieve higher power output. Three phase or split phase operation is also possible. Please check our datasheets to see which models have paralleling, three phase and split phase capabilities.

    Remote Monitoring and Control

    When coupled with a GX device (e.g. Cerbo GX) you can monitor and control your Quattro and system or systems’ locally (LAN) or remotely via the internet from anywhere in the world, using the free VRM app and free VRM portal website. Access can be from a phone, tablet, laptop or PC for multiple operating systems. There is no end to the level of control, from adjusting your Quattro to auto starting a backupgenerator and more…

    R69985,93

    In Stock at Distribution Branch

    Victron Quattro 48/10000/140-100/100 230V VE.Bus

    R69985,93

    In Stock at Distribution Branch

  • Victron MultiPlus 48/5000/70-100 230V VE.Bus

    Unique PowerAssist feature

    The MultiPlus will prevent overload of a limited AC source, such as a generator or shore power connection. First, battery charging will automatically be reduced when otherwise an overload would occur. The second level will boost the output of a generator or shore side supply with power taken from the battery.

    Uninterrupted AC power (UPS function)

    In the event of a grid failure, or when shore or generator power is disconnected, the inverter within the Multi is automatically activated and takes over the supply to the connected loads. This happens so fast (less than 20 milliseconds) that computers and other electronic equipment will continue to operate without disruption.

    Virtually unlimited power thanks to parallel operation

    Up to 6 Multis can operate in parallel to achieve higher power output. Three phase or split phase operation is also possible. Please check our datasheets to see which models have paralleling, three phase and split phase capabilities.

    Remote Monitoring and Control

    When coupled with a GX device (e.g. Cerbo GX) you can monitor and control your Multi and system or systems’ locally (LAN) or remotely via the internet from anywhere in the world, using the free VRM app and free VRM portal website. Access can be from a phone, tablet, laptop or PC for multiple operating systems. There is no end to the level of control, from adjusting your Multi to auto starting a backupgenerator and more…

    R38135,84

    Out of stock

  • Victron MultiPlus 48/3000/35-50 230V VE.Bus

    The Victron MultiPlus 48/3000/35-50 230V VE.Bus, as the name suggests, is a combined inverter and charger in one elegant package. Its many features include a true sine wave inverter, adaptive charging, hybrid PowerAssist technology, and a host of system integration features.

    R17279,13

    In Stock at Distribution Branch

    Victron MultiPlus 48/3000/35-50 230V VE.Bus

    R17279,13

    In Stock at Distribution Branch

  • Victron Quattro 48/8000/110-100/100 230V VE.Bus

    Similar to the MultiPlus, the Victron Quattro 48/8000/110-100/100 230V VE.Bus is also a combined inverter and charger. Additionally it can accept two AC inputs and automatically connect to the active source. Its many features include a true sine wave inverter, adaptive charging, hybrid PowerAssist technology plus multiple system integration features such as three or split phase operation and parallel operation.

    R52386,33

    In Stock at Distribution Branch

    Victron Quattro 48/8000/110-100/100 230V VE.Bus

    R52386,33

    In Stock at Distribution Branch

  • Victron Quattro 48/15000/200-100/100 230V VE.Bus

    Similar to the MultiPlus, the Victron Quattro 48/15000/200-100/100 230V VE.Bus is also a combined inverter and charger. Additionally it can accept two AC inputs and automatically connect to the active source. Its many features include a true sine wave inverter, adaptive charging, hybrid PowerAssist technology plus multiple system integration features such as three or split phase operation and parallel operation.

    R89246,13

    In Stock at Distribution Branch

    Victron Quattro 48/15000/200-100/100 230V VE.Bus

    R89246,13

    In Stock at Distribution Branch

  • Victron MultiPlus-II 48/5000/70-50

    The Victron MultiPlus-II 48/5000/70-50 combines the functions of the MultiPlus and the MultiGrid. It has all the features of the MultiPlus, plus an external current transformer option to implement PowerControl and PowerAssist and to optimize self-consumption with external current sensing (max. 32A). It also has all the features of the MultiGrid with built-in anti-islanding and an increasingly long list of country approvals

    R21575,53

    In Stock at Distribution Branch

    Victron MultiPlus-II 48/5000/70-50

    R21575,53

    In Stock at Distribution Branch

Main Menu

Contact us on WhatsApp